HP VMA-series Memory Arrays Uživatelská příručka stáhnout pdf (Strana 43)

AM456-9025A HP VMA SAN Gateway Installation and Configuration Guide 43

Completing the Replacement

Go to the section that represents your configuration, and follow the steps to complete the

replacement:

• Both Nodes Running G5.1.0 on page 41

• G5.1.0 on mg-b and G5.2.0 or Higher on mg-a on page 41

• Both Nodes Running G5.2.0 or Higher on page 41

Both Nodes Running G5.1.0

If both your existing Memory Gateway node (mg-b) and the newly replaced Gateway node are both

running software version G5.1.0, complete the following steps:

1. While logged in to the newly replaced Memory Gateway node, enter the following command:

2. Watch the command line to ensure that the prompt changes to standby.

G5.1.0 on mg-b and G5.2.0 or Higher on mg-a

If your existing Memory Gateway node (mg-b) is running software version G5.1.0 and the newly

replaced Gateway node is running G5.2.0 or higher, contact HP Customer Support.

Both Nodes Running G5.2.0 or Higher

If both your existing Memory Gateway node (mg-b) and the newly replaced Gateway node are both

running software version G5.2.0, complete the following steps:

1. While logged in to the newly replaced Memory Gateway node, enter the following command at the

prompt:

2. Next, enter this command after the prompt:

The prompt changes to look like the following:

mg-a [violin: master]# cluster id <same_id_as_mg-b>

mg-a [violin: master]# no cluster enable

mg-a [violin: master]# fms enable

mg-a [FRU: searching](config)#

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 82 83

Žádné komentáře

HP VMA-series Memory Arrays Uživatelská příručka Strana 43