HP SCSI Host Bus Adapters Instalační manuál

AB290A PCI-X2-Port U320 SCSI and 2-Port Gigabit EthernetCombination Card Installation GuideFor mpt Driver Versions B.11.11.02 and B.11.23.01 andFor ie

Hardware and Software Installation ProcedureOptional Step: Configure Jumbo Frames Size (Jumbo frames are supported only at 1000 Mbit/s)10AdapterThe las

Hardware and Software Installation ProcedureFor Further Information11Maintenance and troubleshooting information about the drivers used in this produc

Hardware and Software Installation ProcedureNetwork Configuration Worksheet12Network Configuration WorksheetFill out one worksheet for the networking da

Hardware and Software Installation ProcedureNetwork Configuration Worksheet13Note 3: Following are the valid MTU sizes:• For normal frames using the ie

Hardware and Software Installation ProcedureProduct Overview and Requirements14Product Overview and RequirementsThe AB290A PCI-X Combination cards hav

Hardware and Software Installation ProcedureInteroperability: Supported Systems15Interoperability: Supported SystemsSupported SystemsThe combination c

Card Physical and Environmental Specs and Regulatory InformationCard Physical and Environmental Specifications16Card Physical and EnvironmentalSpecs an

Card Physical and Environmental Specs and Regulatory InformationFCC Statement (For U.S.A.)17Electromagnetic CompatibilityThis document contains regula

Card Physical and Environmental Specs and Regulatory InformationEMI Statement (European Community)18

2Legal NoticesThe information in this document is subject to change without notice.Hewlett-Packard makes no warranty of any kind with regard to this m

Hardware and Software Installation ProcedureStep 1: Access the system card bay3Hardware and Software Installation ProcedureThese instructions apply to

Hardware and Software Installation ProcedureStep 2: Install the card4Step 2: Install the card• Check the latest support matrixes to see the systems th

Hardware and Software Installation ProcedureStep 4: Connect the SCSI peripherals5Step 4: Connect the SCSI peripheralsYou can connect as many as 15 oth

Hardware and Software Installation ProcedureStep 6: Prepare to install the software6IMPORTANT You must not have duplicate SCSI IDs on a SCSI bus; the

Hardware and Software Installation ProcedureStep 8: Configure the card using SAM7• Click the Source Depot Path to identify the registered depot for the

Hardware and Software Installation ProcedureStep 9: Verify the SCSI installation81000Base-T Adapter/dev/mpt8ext_bus 9 1/0/4/0/1 mpt CLAIMED INTERFACE

Hardware and Software Installation ProcedureStep 10: Verify the LAN installation9---------------------------------------------------------------------