HP NetServer LH 6000 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Barebones pro PC / pracovní stanice HP NetServer LH 6000. HP Netserver LH 6000 with NetRAID Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 6
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
1
HP Netserver LH 6000
with
NetRAID-4M (HP Rack Storage/12)
Windows NT
Server 4.0 Enterprise Edition
Cluster Configuration Guide
6 June 2001
(see Versions at the end of this document)
Introduction
This document defines the configurations that Hewlett-Packard supports for the HP Netserver LH 6000,
HP Rack Storage/12 and Microsoft
Cluster Server. These configurations minimize single points of
failure (SPOF) and provide extended availability. The specific configuration certified and supported by
both Hewlett-Packard and Microsoft
is defined, as are other guidelines to assist you in configuring your
clustered Netservers. This guide is prescriptive; it describes the configurations supported by HP. Any
deviance to these configurations can result in an inoperative cluster or an operating cluster with degraded
performance, hidden SPOFs, etc., and therefore will not be supported by HP.
What's Defined in a Cluster
Cluster
SPUs
Local and Shared Storage
Intra-cluster and Client LANs
Shared Storage Cabling
Cluster
Type of SPUs HP Netserver LH 6000
Each node must be the same SPU, but may have different clocks speeds,
main memory sizes, cache sizes, and number of CPUs.
Number of nodes 2
Shared Storage HP Rack Storage/12 with HP NetRAID-4M controller and HP disks. See
Shared Storage below.
LANs:
Client LAN Any NIC that is HP and Microsoft
approved. See Client LAN below.
Intra-cluster
(Heartbeat) LAN
Embedded NIC with crossover cable or equivalent. See Intra-cluster LAN
below.
Power source Direct from power mains, power conditioner or uninterruptible power
Zobrazit stránku 0
1 2 3 4 5 6

Shrnutí obsahu

Strany 1 - 6 June 2001

1HP Netserver LH 6000withNetRAID-4M (HP Rack Storage/12)Windows NT Server 4.0 Enterprise EditionCluster Configuration Guide6 June 2001(see Versions a

Strany 2

2supply (UPS) using any power conditioner or UPS. Redundant powerdistribution units (PDU’s) are strongly recommended.System software: Navigator v

Strany 3

3 Channels 0, 1, 2, 3 RAID levels All fault tolerant RAID types supported by controller: 1, 5, 10 (Stripe setof mirror sets RAID 0/1), 50 (Str

Strany 4

4HP Netserver LH 6000 Cluster using HP Rack Storage/12

Strany 5

5Power Cabling to Separate Power Circuits

Strany 6 - Versions

6Versions6 June 2001 Initial releaseCopyright 2001, Hewlett-Packard Company

Komentáře k této Příručce

Žádné komentáře