HP Compaq dx2200 MT Uživatelská příručka stáhnout pdf (Strana 21)

Hardware Reference Guide www.hp.com 1-17

Hardware Upgrades

To install a drive, reverse the removal procedure. Refer to the

following table for proper retainer and guide screw locations.

✎

If you are installing a drive in the external 3.5" drive bay for the first

time, use a flatblade screwdriver to pry out the metal shield covering

the bay.

✎

There are a total of eight extra guide/retainer screws on the front of

the chassis behind the bezel. Four have 6-32 standard threads and four

have M3 metric threads. Standard screws are used for hard drives and

have a silver finish. Metric screws are used for all other drives and

have a black finish. Be sure to install the appropriate guide screws

into the drive.

Device Retainer Screws Guide Screws

Diskette Drive 2 (labeled “FDD” on chassis) 1 (front left side of

drive)

Media Card

Reader

2 (labeled “CR” on chassis) none

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 30 31

Žádné komentáře

HP Compaq dx2200 MT Uživatelská příručka Strana 21