Hp Integrity rx4610 Server Uživatelský manuál stáhnout pdf (Strana 47)

Chapter 5: Installing Additional Memory

9. Place the memory board on a clean ESD-protected surface.

Figure 5-4. Memory Boards

Installing Memory Boards

Two memory boards exist, one plugged into each side of the Processor Baseboard (the top and the

underside of the Processor/Memory Complex). This procedure describes the installation process for

either memory board. To re-install the memory board or install a new board, complete the following

procedure:

1. Observe all safety and ESD precautions.

2. Remove the Processor/Memory Complex as described in “Removing the Processor/Memory

Complex” in Chapter 5.

3. With both extraction levers raised to engage the guide pins, place the memory board over the

Processor Baseboard connector and guide pins

4. Engage both guide pins at the same time. Ensure that the memory board remains parallel to

the Processor Baseboard.

NOTE Both extraction levers must be depressed evenly while inserting the Memory

Board. The Memory Board must remain parallel to the Processor Baseboard

during insertion.

5. Slowly depress the levers until the Memory Board connector fully engages.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 200 201

Žádné komentáře

Hp Integrity rx4610 Server Uživatelský manuál Strana 47