Hp DL385 Uživatelský manuál stáhnout pdf (Strana 52)

Hardware options installation 52

Remove the hard drive.

Installing a diskette drive

NOTE: This procedure shows images of the SCSI model server, but it also applies to the SAS model server.

1. Power down the server (on page 27).

2. Extend the server from the rack, if applicable ("Extend the server from the rack" on page 28).

3. Remove the access panel ("Removing the access panel" on page 29).

4. Remove the protective cover on the server bezel from the front of the diskette drive bay.

5. Slide the diskette drive into the diskette drive bay.

6. Tighten the thumbscrew.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 123 124

HP ProLiant DL385 Server 1
User Guide 1
Audience assumptions 2
Contents 3
Contents 4 4
Contents 5 5
Contents 6 6
Front panel components 8
Front panel LEDs and buttons 9
Rear panel components 10
Rear panel LEDs and buttons 11
System board components 12
System maintenance switch 13
NMI jumper 13
DIMM slots 14
SCSI backplane components 15
SAS backplane components 16
System board LEDs 16
SCSI backplane LEDs 19
Hot-plug SAS hard drive LEDs 21
PCI riser cage LED 22
Remote management connector 23
Identifying hot-plug fans 23
Hot-plug fan LED 24
Power converter module LED 24
Server operations 27
Removing the access panel 29
Installing the access panel 29
Removing the PCI riser cage 31
Front fan bracket 32
Server operations 33 33
Server setup 34
Rack planning resources 35
Optimum environment 35
Temperature requirements 36
Power requirements 36
Rack warnings 37
Installing hardware options 38
Server setup 40 40
Registering the server 41
Introduction 42
Processor option 42
11. Install the heatsink 44
Memory options 45
DIMM installation guidelines 46
Installing DIMMs 46
SCSI IDs 47
SAS drive numbers 50
Installing a diskette drive 52
Hot-plug tape drive option 53
Redundant hot-plug fans 54
Expansion board options 59
Server cabling 64
USB cabling 65
DVD/CD-ROM drive cabling 66
Diskette drive cabling 66
Power button/LED cabling 67
RILOE cabling (SAS) 67
SCSI model cabling 68
Embedded duplex SCSI cabling 69
PCI simplex SCSI cabling 70
PCI duplex SCSI cabling 71
Mixed duplex SCSI cabling 71
RILOE cabling (SCSI) 77
Internal power cabling 77
Configuration tools 78
HP ROM-Based Setup Utility 79
Array Configuration Utility 80
Management tools 82
Management Agents 83
HP Systems Insight Manager 83
Erase Utility 83
Redundant ROM support 84
System maintenance menu 85
USB support 85
Diagnostic tools 86
Keeping the system current 87
Care Pack 88
Troubleshooting 89
Symbols on equipment 90
Warnings and cautions 90
Symptom information 91
Loose connections 92
Service notifications 92
Troubleshooting flowcharts 93
General diagnosis flowchart 94
Symptoms: 96
Troubleshooting 98 98
POST problems flowchart 99
OS boot problems flowchart 100
Troubleshooting 102 102
Possible causes: 103
Redundancy failure 103
Troubleshooting 104 104
Troubleshooting 105 105
Troubleshooting 106 106
Battery replacement 107
Electrostatic discharge 108
In this section 109
FCC rating label 109
Class A equipment 109
FCC logo, United States only 110
Modifications 110
• EMC Directive 89/336/EEC 111
Japanese notice 112
BSMI notice 112
Korean notice 113
Laser compliance 113
Battery replacement notice 113
Server specifications 115
Server specifications 116 116
Power supply output 116
Maximum peak power 575 W 116
Technical support 117
Customer self repair 118
Acronyms and abbreviations 119
Index 122 122
Index 123 123
Index 124 124

Komentáře k této Příručce

Žádné komentáře

Hp DL385 Uživatelský manuál Strana 52

Komentáře k této Příručce

Související produkty a manuály pro Počítače Hp DL385