Hp LC 2000 Uživatelský manuál stáhnout pdf (Strana 35)

Chapter 3 Opening and Closing the HP NetServer

Top Cover

Bottom Cover

Cover Pull

Figure 3-5. Removing HP NetServer LC 2000r Covers

15. If necessary, remove the bottom cover by loosening the thumbscrew at the

front of the HP NetServer with one hand. See Figure 3-5.

The bottom cover does not provide any additional access to the interior,

except the bottom of the mass storage drives and the control panel board.

16. Support the bottom cover with your free hand, as you pull the cover

forward to disengage it, catching it as it falls away from the chassis. See

Figure 3-5.

17. To replace the top cover, position the cover’s tabs over the respective holes

along the top edge on both sides of the chassis.

18. Slide the cover toward the rear.

19. Tighten the thumbscrew at the front of the cover.

20. To replace the bottom cover, position the cover’s tabs under the respective

holes along the bottom edge on both sides of the chassis.

21. Slide the cover toward the rear.

22. Tighten the thumbscrew at the front of the cover.

23. Release the safety latches in the slide members on both sides of the chassis.

See Figure 3-4.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 193 194

Žádné komentáře

Hp LC 2000 Uživatelský manuál Strana 35