Hp Z210 Convertible Minitower-Workstation Uživatelský manuál Strana 55

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 68
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 54
4. Push the sled containing the HDD into the selected bay until it snaps into place (1) as shown in the
following figure.
Figure 9-3 Installing the HDD drive
5. Attach a power cable (2), and a data cable (3), to the hard disk drive.
CAUTION: To avoid crushing or pinching the data cable when you replace the access panel,
use the HP-supplied data cable with right-angle connectors.
NOTE: Connect data cables to lower-numbered drive connectors first on the system board. To
identify hard disk drive ports, refer to the workstation service label on the side access panel.
NOTE: Blue SATA ports (numbered zero and one) support SATA Gen 3 (6 Gbit/sec).
6. Replace all components that were removed in preparation for component installation.
Installing an HDD in an HP Z210 SFF Workstation
To install an HDD:
1. Follow the procedures described in
Preparing for component installation on page 34 to prepare
the workstation for component installation.
ENWW
Installing a hard disk drive
47
Zobrazit stránku 54
1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 67 68

Komentáře k této Příručce

Žádné komentáře