HP D2D2502i Uživatelská příručka stáhnout pdf (Strana 83)

serviceset stop

Description of Command Function

This command stops the service sets. The command will either stop the service set defined in the

command sequence or if parameter “all” is included in the command sequence, all the service sets

in the cluster will be sopped.

IMPORTANT: This command will stop the service set independent of the existing state of the

service set.

Command Syntax

serviceset stop [SETX] [all]

Command Authority

Administrator

Command Object Requirements

SET

— This optional object defines an individual service set. X is a unique numeric index. If the

object is not included in the command sequence, the parameter “all” must be included in the

command sequence.

Command Parameter Requirements

all — This parameter is optional. If included in the command sequence, all the service sets in the

cluster are stopped. If this command is not included, a service set object must be included in the

command sequence.

Requirements for Command Execution

• The command entry must conform to the command syntax.

• If a service set is defined in the command sequence, it must exist.

Successful Command Output

Upon successful completion of the command, the service sets defined in the command sequence

are stopped and the following is displayed:

Command Successful

Command Operation During Abnormal Conditions

• If the command does not conform to the required syntax, the following message is displayed:

Command Failed - the command does not conform to the required syntax,

SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this

section.

• If the chosen service set is not stopped, the following message is displayed:

Command Failed — The service set <SETX> does not exist

Example

# serviceset stop set 1

Command Successful

serviceset stop 83

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 177 178

Žádné komentáře

HP D2D2502i Uživatelská příručka Strana 83