HP Data Center Environmental Edge Instalační manuál stáhnout pdf (Strana 50)

(Optional) Sensor Base Stations 50

If a flat surface is available, remove the mounting tape liner and secure the base station to the

surface.

b. If a support bracket is available, use cable ties to secure the base station to the support bracket.

2. Connect the Current Sensing Relay Base Station to your current sensor.

a. Strip the plastic coating from the ends of the two wires on the wire harness labeled CH 3.

b. Using a flathead screwdriver, secure the white wire to the positive terminal block on the current

sensor transducer.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 81 82

Žádné komentáře

HP Data Center Environmental Edge Instalační manuál Strana 50