HP EliteDesk 705 G1 Small Form Factor PC (ENERGY STAR) Uživatelský manuál

Technical white paper Advanced Host Controller Interface (AHCI) and Redundant Array of Independent Disks (RAID) on HP EliteDesk and EliteOne 705 Bu

10 7. Press C to create the array. 8. Press Esc to exit. At system prompt, press Y to reboot or any other key to go back. Select boot order

11 3. When the load driver error window appears (below), insert the RAID driver flash drive and click Browse. 4. Navigate to the directory wher

12 6. Select the partition for the OS to be installed and click Next. The OS will install. Failure to install and enumerate the RAID driver aft

13 4. Click Submit. Recommended Initial Settings These recommended settings are most effective if you accept the initial recommended settings no

14 4. Type the same password into the Confirm New Password box. With the Notification option, you can manage event log and email notifications

15 2. Specify the Outgoing Mail Server (SMTP) and To Email Address, to which email messages are sent when an event occurs. 3. If the SMTP server r

2 Introduction A Redundant Array of Independent Disks (RAID) is a data storage scheme that uses two or more drives accessed in combination to impro

3 PnP Plug and Play, automated hardware discovery and configuration. POST Power-On Self Test, a BIOS-initiated routine that executes when a syste

4 Table 3: RAID 0 with two hard drives (Striped) First disk Second disk Data Segment 1 Data Segment 2 Data Segment 3 Data Segment 4 Data Se

5 RAID 1 with two hard drives (Mirror) RAID 1 has redundancy and hence is a true RAID, which greatly increases reliability. The probability of one h

6 Recommended configurations for HP EliteDesk and EliteOne 705 Business PCs For best reliability, HP recommends factory configurations of the prein

7 Enabling RAID through F10 System BIOS 1. Turn on or restart the computer by clicking Start > Shut Down > Restart the Computer. 2. Press

8 WARNING: Before configuring RAID, be sure to back up all data. Once a RAID configuration is executed and saved, data on the selected disks will n

9 4. Select Create Array, and then press Enter. 5. Use the A key or Ins key to select the disks to include in the RAID configuration. Press Ente