HP 14-3100eb SPECTRE Technické informace Strana 71

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 98
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 70
Reverse this procedure to install the processor heat sink.
Remove the post controller hub heat sink:
1. Loosen the captive Philllips screw (1) that secures the post controller hub heat sink to
the system board.
2. Remove the post controller hub heat sink (2).
NOTE: Due to the adhesive quality of the thermal material located between the post controller
hub heat sink and system board, it may be necessary to move the post controller hub heat sink
from side to side to detach it.
The thermal material must be thoroughly cleaned from the surfaces of the post controller hub heat sink
and the post controller hub each time the post controller hub heat sink is removed. Replacement thermal
material is included with the post controller hub heat sink and system board spare part kits.
Component replacement procedures
63
Zobrazit stránku 70
1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 97 98

Komentáře k této Příručce

Žádné komentáře