HP 4530s Uživatelský manuál stáhnout pdf (Strana 120)

Using System Diagnostics

System Diagnostics allows you to run diagnostic tests to determine if the computer hardware is

functioning properly. The following diagnostic tests are available in System Diagnostics:

●

Start-up test—This test analyzes the main computer components that are required to start the

computer.

●

Run-in test—This test repeats the start-up test and checks for intermittent problems that the start-up

test does not detect.

●

Hard disk test—This test analyzes the physical condition of the hard drive, and then checks all

data in every sector of the hard drive. If the test detects a damaged sector, it attempts to move the

data to a good sector.

●

Memory test—This test analyzes the physical condition of the memory modules. If it reports an

error, replace the memory modules immediately.

●

Battery test—This test analyzes the condition of the battery. If the battery fails the test, contact HP

Customer Support to report the issue and purchase a replacement battery.

You can also view system information and error logs in the System Diagnostics window.

To start System Diagnostics:

1. Turn on or restart the computer. While the “Press the ESC key for Startup Menu” message is

displayed in the lower-left corner of the screen, press esc. When the Startup Menu is displayed,

press f2.

2. Click the diagnostic test you want to run, and then follow the on-screen instructions.

NOTE: If you need to stop a diagnostics test while it is running, press esc.

112 Chapter 5 Computer Setup (BIOS) and System Diagnostics

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 149 150

Žádné komentáře

HP 4530s Uživatelský manuál Strana 120