HP Compaq Elite 8200 AIO Uživatelská příručka stáhnout pdf (Strana 14)

In addition, the computer supports:

● 512-Mbit, 1-Gbit, and 2-Gbit non-ECC memory technologies

●

single-sided and double-sided SODIMMS

●

SODIMMs constructed with x8 and x16 devices; SODIMMs constructed with x4 SDRAM are not

supported

NOTE: The system will not operate properly if you install unsupported SODIMMs.

There are two memory sockets on the system board located behind the memory access panel. To

remove or install memory modules:

1. Remove/disengage any security devices that prohibit opening the computer.

2. Remove all removable media, such as compact discs or USB flash drives, from the computer.

3. Turn off the computer properly through the operating system, then turn off any external devices.

4. Disconnect the power cord from the power outlet and disconnect any external devices.

CAUTION: You must disconnect the power cord and wait approximately 30 seconds for the

power to drain before adding or removing memory modules. Regardless of the power-on state,

voltage is always supplied to the memory modules as long as the computer is plugged into an

active AC outlet. Adding or removing memory modules while voltage is present may cause

irreparable damage to the memory modules or system board.

5. Place the computer face down on a soft flat surface. HP recommends that you set down a

blanket, towel, or other soft cloth to protect the screen surface from scratches or other damage.

6. Remove the center access panel by pulling outward on the panel at the slot on the top edge of

the panel.

Figure 2-2 Removing the Center Access Panel

8 Chapter 2 Hardware Repair and Upgrade ENWW

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 30 31

Žádné komentáře

HP Compaq Elite 8200 AIO Uživatelská příručka Strana 14