HP omnibook XE2 Uživatelský manuál stáhnout pdf (Strana 53)

HP OmniBook XE2 Troubleshooting and Diagnostics 3-11

Diagnostic Tools

This section describes the following diagnostic tools you can use for troubleshooting and repairing the

OmniBook:

• OmniBook hardware diagnostic program (below).

• Power-on self-test (page 3-16).

• Desktop Management Interface (page 3-20).

• BIOS Setup utility (page 3-22).

OmniBook Diagnostic Program

The OmniBook hardware diagnostic program provides two levels of testing:

• User-level testing using the basic hardware test.

• Advanced testing using the individual hardware tests.

Figure 3-2. OmniBook Diagnostic Screens, Basic and Advanced

The tests are designed to run after the system reboots. This ensures that the computer will be in a

predictable state, so the diagnostic program can properly test the hardware components. The tests are

non-destructive and are intended to preserve the state of the computer. The OmniBook reboots when

you exit the program so drivers can be loaded.

Creating a Diagnostic Floppy Disk

After inserting a formatted floppy disk in the floppy drive, do one of the following to create a

diagnostic floppy disk:

• On an OmniBook with a factory software installation, run

diaginst from the \Dmi\Hpdiags

directory on the hard disk.

–or–

If TopTools is installed, use the DiagTools page to create the disk.

• On any computer with a CD-ROM drive, run

diaginst from the \Omnibook\Drivers\Hputils

directory on the OmniBook Recovery CD.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 84 85

Žádné komentáře

HP omnibook XE2 Uživatelský manuál Strana 53