HP Omnibook XE3 Uživatelský manuál stáhnout pdf (Strana 62)

2-34 Removal and Replacement HP OmniBook XE3

Removing the Motherboard or Bottom Case

(HP Authorized Service Providers Only)

Required Equipment

• Small Phillips screwdriver.

• 5mm socket driver.

When Installing a New Motherboard

Before replacing the motherboard, you must (if possible) electronically store the motherboard’s serial

number and service ID for transfer to the new motherboard.

1. Exit Windows and boot to a DOS prompt:

• For Windows 98 or ME, press F8 during reboot and select Command Prompt Only.

• For Windows 2000, boot from a DOS boot floppy disk.

2. Run ESN.EXE from one of these sources:

• On a factory software installation, change to the \HP\Drivers\Hputils directory and type

esn at

the prompt.

• Otherwise, copy \HP\Drivers\Hputils\ESN.EXE from the Recovery CD, then run it on the

notebook.

3. Save the serial number and service ID.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 115 116

Žádné komentáře

HP Omnibook XE3 Uživatelský manuál Strana 62