HP 400 G1 Specifikace stáhnout pdf (Strana 117)

6. Press inward on the release lever at the rear of the device (1) and slide the device out of the rear

of the drive bay (2).

Installing a 3.5-inch device

1. Prepare the computer for disassembly (Preparation for disassembly on page 90).

2. Remove the access panel (

Access panel on page 91).

3. Remove the front bezel (

Front bezel on page 92). If you are installing a drive in a bay covered by

a bezel blank, remove the bezel blank. See

Bezel blanks on page 94 for more information.

4. Install 6-32 guide screws in the holes on each side of the device.

NOTE: HP has supplied four extra 6-32 guide screws on top of the drive cage. Refer to Drives

on page 103 for an illustration of the extra guide screws location.

When replacing a device, transfer the four 6-32 guide screws from the old device to the new one.

Drives

107

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 239 240

Žádné komentáře

HP 400 G1 Specifikace Strana 117