HP Z600 Specifikace stáhnout pdf (Strana 147)

Installing a PCIe card

1. Disconnect power from the workstation (see Predisassembly procedures on page 73).

2. Remove the side access panel (see

Removing the side access panel on page 75).

NOTE: An expansion card support is built into the side access panel. When the panel is removed,

the card support is removed, allowing access to the expansion cards.

3. Select the desired expansion card slot for the PCIe card. (See Choosing an expansion card slot

on page 133 for help in selecting a slot.)

4. Push the expansion card retention clamp levers down on the outside of the chassis to release the

retention clamp as shown in the following figure

Figure 5-77 Removing the slot cover

5. Remove the PCI slot cover by pulling it up, out of the chassis

TIP: Grasp the slot cover between two fingers—one from the inside of the chassis, and one from

the outside.

ENWW Removing and installing components 135

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 237 238

Žádné komentáře

HP Z600 Specifikace Strana 147