HP Z800 Specifikace stáhnout pdf (Strana 185)

If required by the card, connect the auxiliary power cable to the card, as shown in the following

figure:

While pressing on the connector cable release (1), pull the connector away from the

receptacle on the expansion card guide/front fan holder (2).

Connect the cable to the card (3).

Figure 5-98 Connecting the auxiliary power cable

If required by the card, connect other cables or accessories described in the card instructions.

10.

Close the expansion card retention clamp by rotating it downward. The retention clamp is secured

by the expansion card support.

NOTE: It is normal for the expansion card retention clamp to have a slight (5-10 degree) angle

when closed. If the angle is greater than this, open the clamp and ensure that all cards are

properly seated and all the brackets are mated to the chassis, then re-close the clamp.

11.

Install the expansion card support (see

Installing the expansion card support on page 85).

12.

Reinstall all removed components and reconnect any cables that have been disconnected.

ENWW

Removing and installing components

173

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 303 304

Žádné komentáře

HP Z800 Specifikace Strana 185