HP HyperFabric Instalační manuál stáhnout pdf (Strana 87)

Configuring HyperFabric

Information You Need

Chapter 4

❏ For each node in the fabric, you need the IP address of the node’s Ethernet LAN

interface that is on the same subnet as the switches. (As mentioned earlier, a node

might have multiple LAN interfaces.) Note that if you do not have switch

management enabled, you do not need this information (clic_init will not prompt

you for it).

As stated earlier, we recommend that you do not enable switch management.

IMPORTANT You should also check your /etc/hosts file—when you are using files for host name look

up—to ensure that the entries for all of the systems are in the correct format: the official

host name, which is the full domain extended host name, and any alias names. For

example:

IP_address bently6.corp3.com bently6

IP_address bently4.corp7.com test1

IP_address bently2.corp4.com test3

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 155 156

Žádné komentáře

HP HyperFabric Instalační manuál Strana 87