HP 100Base-T Uživatelská příručka stáhnout pdf (Strana 15)

Installing the System 2-1

Chapter 2: Installing the System

This chapter provides information on installing the HP 100Base-T Hub 8,

establishing network connections, and configuring the system. You may

install this hub on any level surface (e.g., a table or shelf) or in a standard

EIA equipment rack. A mounting kit is available (5183-7210).

Please take note of the following minimum site requirements before you

begin.

Pre-Installation Requirements

Before you start actual hardware installation, make sure you can provide

the right operating environment, including power requirements, sufficient

physical space, and proximity to other network devices that are to be

connected. Verify the following installation requirements:

■ Power connector requirements: 13-19 Vdc, 800 mA.

■ Power source: One of the following external power adapters.

* Specifications shown on adapter label.

■ The hub should be located in a cool dry place, with at least 10 cm. of

space at the front and back for ventilation.

■ Place the hub out of direct sunlight, and away from heat sources or areas

with a high amount of electromagnetic interference.

Country Adapter P/N Input Specs.* Output Specs.*

China 0950-3269 220-240 Vac, 50 Hz 19 Vdc, 800 mA

USA 0950-3274 110-127 Vac, 60 Hz 19 Vdc, 800 mA

Europe 0950-3268 230 Vac, 50 Hz 19 Vdc, 800 mA

Australia 0950-3269 220-240 Vac, 50 Hz 19 Vdc, 800 mA

Japan 0950-3267 100 Vac, 50/60 Hz 19 Vdc, 0.8 A

UK 0950-3270 220-240 Vac, 50 Hz 19 Vdc, 800 mA

Switzerland 0950-3268 230 Vac, 50 Hz 19 Vdc, 800 mA

Denmark 0950-3268 230 Vac, 50 Hz 19 Vdc, 800 mA

100hub8.book : 100hub82.fm Page 1 Monday, April 27, 1998 10:06 AM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

Žádné komentáře

HP 100Base-T Uživatelská příručka Strana 15