HP 620n Uživatelská příručka stáhnout pdf (Strana 215)

ENWW HP Jetdirect Configuration Page 215

TCP/IP Protocol Information

Information in this section of the Jetdirect configuration page is

described in Table 9.6

. For error messages, see Table 9.11.

Table 9.6 TCP/IP Configuration Information (1 of 4)

Message Description

STATUS: Current TCP status.

READY: Indicates the HP Jetdirect print server is awaiting

data over TCP/IP.

DISABLED: Indicates that TCP/IP was manually disabled.

INITIALIZING: Indicates that the print server is searching

for the BOOTP server, or trying to get the configuration file

through TFTP. An additional status message may also be

displayed.

An error code and message is displayed if the print server

is not ready. For more information, see Table 9.11

HOST NAME: The host name configured on the print server. It may be

truncated.

NOT SPECIFIED: Indicates that no host name was

specified in a BOOTP response or TFTP configuration file.

NPIxxxxxx: The default name is NPIxxxxxx, where xxxxxx

represents the last six digits of the LAN hardware (MAC)

address.

IP ADDRESS: The Internet Protocol (IP) address assigned to the

HP Jetdirect print server. This is a required entry for

operation of the print server on a TCP/IP network. During

initialization, a temporary value 0.0.0.0 is displayed. After

two minutes, a default IP address 169.254/16 or

192.0.0.192 is assigned.

NOT SPECIFIED: Indicates that an IP address is not

assigned or the value is zero.

SUBNET MASK: The IP subnet mask configured on the HP Jetdirect print

server. During initialization, a temporary value 0.0.0.0 is

displayed. Depending on configuration parameters, the

print server may automatically assign a usable default

value.

NOT SPECIFIED: Indicates that a subnet mask is not

configured.

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 263 264

Žádné komentáře

HP 620n Uživatelská příručka Strana 215