HP AdvanceStack Router 230 Instalační manuál Strana 23

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 144
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 22
1. Ensure that the LAN cable is properly grounded. (Refer to ‘‘Safety
Information’’ in the back of this manual.)
2. Attach a ThinLAN cable section to one side of a BNC ‘‘T’’ connector.
3. Attach another ThinLAN cable section or a 50-ohm terminator to the
other side of the ‘‘T’’ connector.
Note Each coaxial cable segment must be terminated with a 50-ohm
terminator at each end. Figure 1-13 shows the ThinLAN port at the end
of a cable segment, with the 50-ohm terminator attached to one side of
the BNC ‘‘T’’ connector.
4. Attach the “T” connector to the BNC port on the router.
5. Fold the BNC ‘‘T’’ connector cover around the connection and
squeeze the surfaces together around the edges.
Figure 1-14.The Installed BNC Connector Cover
Figure 1-12.BNC Connector -- Mid-Cable Figure 1-13.BNC Connector -- End-of-Cable
Installation
1
Installation
Phase 3: Prepare the Router Hardware
1-15
Zobrazit stránku 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 143 144

Komentáře k této Příručce

Žádné komentáře