HP AlphaStation DS20 Instalační příručka stáhnout pdf (Strana 11)

Linux Installation and Configuration Guide for AlphaServer 11

ECG513/0100

After booting, the installation program begins by displaying the language screen. Using the

mouse point and click on the next button. The GUI is easy to follow. If you decided to install the

X Window System, the amount of video RAM available on the Elsa Gloria Card is 8

megabytes. Please refer to the Red Hat Installation guide for further details.

Post-Installation

System Resource Manager Configuration

After the software has been loaded to the disk, the system will attempt to reboot. Before it begins

the bootup process, press the front panel reset button. This will stop the bootup process, and

allow you to make the final configuration changes to be able to boot directly from the disk,

instead of the floppy or CD-ROM. You should now be at the SRM prompt, ">>>". Enter the

following commands to finalize the configuration.

You need to enter these commands, such that the drive reference on the second line needs to refer

to the drive which you installed to:

>>>set boot_file

>>>set bootdef_dev dka0

(or whatever device you installed on. It could also be dqa0 for an

IDE drive. See Appendix C for further information on systems with

IDE controllers.)

>>>set boot_osflags 0

At the SRM prompt, you can now boot directly from the hard drive.

>>>boot

SuSE Version 6.3 Distribution

Firmware Inspection and Upgrade

After powering up your AlphaServer computer, type the command "show version". Check that

the version string printed is "V5.4-2 May 19 1999 14:25:16" or newer, and that the first letter of

the version string is a "V". If this is not the case, you should upgrade your firmware. Instructions

on how to do this can be found at http://ftp.digital.com/pub/Digital/Alpha/firmware/ along with

the latest firmware images.

System Resource Manager Configuration

There are several pieces of information that you need to configure in the SRM subsystem, as well

as device identifiers that you should make note of, prior to beginning the installation process. The

steps that follow take you through that process.

1. Power up your system. After several diagnostics are completed, you will be presented an

SRM prompt ">>>", as shown here:

1024 Meg of system memory

probing hose 0, PCI

probing PCI-to-ISA bridge, bus 1

probing PCI-to-PCI bridge, bus 2

probing PCI-to-PCI bridge, bus 3

bus 0, slot 9 -- ewa -- DE500-BA Network Controller

bus 0, slot 11 -- ewb -- DE500-BA Network Controller

bus 0, slot 13 -- dqa -- Acer Labs M1543C IDE

bus 0, slot 13 -- dqb -- Acer Labs M1543C IDE

bus 0, slot 14 -- vga -- ELSA GLoria Synergy

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

Komentáře k této Příručce

Žádné komentáře

HP AlphaStation DS20 Instalační příručka Strana 11

Komentáře k této Příručce

Související produkty a manuály pro Barebones pro PC / pracovní stanice HP AlphaStation DS20