HP Blade Workstation Client Rychlý návod stáhnout pdf (Strana 30)

26 www.hp.com Getting Started

Getting Started

Red Power LED

flashes two times,

once every

second, followed

by a two-second

pause. The beeps

continue for five

iterations, then

stop. The LED

flashes continue

until the problem

is resolved.

2 Processor thermal

protection

activated:

A fan may be

blocked or not

turning.

OR

The heatsink/fan

assembly is not

properly attached

to the processor.

1. Ensure that the

computer air vents

are not blocked and

the processor cooling

fan is running. Leave

a 4-inch (10.2-cm)

clearance at the back

of unit and above the

monitor to permit

required airflow.

2. Open hood, press

power button, and

see if the processor

fan spins. If the

processor fan is not

spinning, make sure

the fan's cable is

plugged onto the

system board header.

Ensure the fan is

fully/properly seated

or installed.

3. If fan is plugged in

and seated properly,

but is not spinning,

then replace

processor fan.

4. Reseat processor

heatsink and verify

that the fan assembly

is properly attached.

5. Contact an

authorized reseller or

service provider.

Diagnostic Front Panel LEDs and Audible Codes

Activity Beeps

Possible

Cause

Recommended

Action

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37 38

Komentáře k této Příručce

Žádné komentáře