HP HP ProCurve Series 6600 Specifikace stáhnout pdf (Strana 29)

2-5

Installing the Switch

Installation Procedures

Installing the Switch

The switch is now fully installed. Refer to the appropriate section in this

chapter for detailed information on any installation step.

1. Prepare the Installation Site

Cabling Infrastructure - Ensure the cabling infrastructure meets the

necessary network requirements. See Appendix B “Cabling and Technology

Information” for detailed information.

Installation Location - Before installing the switch, plan its location and

orientation relative to other devices and equipment:

■ In the front of the switch, leave at least 7.6 cm (3 inches) of space for the

twisted-pair fiber-optic cabling and for cooling. See Figure 2-5 for the air

flow direction.

■ In the back of the switch, leave at least 3.8 cm (1 1/2 inches) of space for

the power cord and cooling.

2. Verify the Switch Passes Self-Test

Before mounting the switch in its network location, you should first verify it

is working properly by plugging it into a power source and verifying it passes

self-test.

1. Connect the power cord shipped with the switch to the power connector

on the back of the power supply, and then into a properly grounded

electrical outlet.

Figure 2-1. Connecting the Power Cord

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 115 116

Žádné komentáře

HP HP ProCurve Series 6600 Specifikace Strana 29