HP LaserJet 4100 Uživatelská příručka

HP®LASERJET 4100TONER CARTRIDGE REMANUFACTURING INSTRUCTIONSHP 4100 TONER CARTRIDGE© 2011 UniNet Imaging Inc. All trademark names and artwork are prop

10. To remove the magnetic roller, carefully lift the roller upand out of the cartridge. Be very careful not to damage thewire contact at the opposite

14. Clean the small end cap contacts with a cotton swaband alcohol.15. Inspect the end caps on the magnetic roller sleeve.Make sure they are not crack

NOTE: The only way to seal this cartridge is to either split or replace the hopper. This is an issue with this cartridge because ofthe contacts that a

19. Coat the OPC drum with the Kynar, and replace the OPC drum and axle pin. Do not install the screws yet. Manually spin theOPC drum in the proper di

CHANGING PRINTER DENSITY SETTING1. To set the intensity, first turn the printer offline (press the GO button).2. Press the menu button four times unti

PRINTER CLEANING PAGEAccording to HP, the printer cleaning page should be run every time a cartridge is changed or when the print quality deteriorates

HP LASERJET 4100 TONER CARTRIDGE REMANUFACTURING INSTRUCTIONSREMANUFACTURING THEHP LASERJET 4100 TONER CARTRIDGEBy Mike Josiah and the Technical Staff

One interesting note: we have tested so far, two new HP C8061X cartridges to ASTM standards. On both cartridges we ran out oftoner at approximately 8,

If you already own an HP 4000, you CAN test the 4100 cartridges in it. The 4100 cartridges are backwards compatible.However If you are going to test y

While we are on the topic of error messages, 54.1 tells the user to remove the sealing tape from the cartridge! This is sure to bea favorite of your c

HP LASERJET 4100 TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS© 2011 UniNet Imaging Inc. All trademark names and artwork are property of their respecti

1. Place the cartridge with the drum side up. Note on each endof the cartridge, there are small silver pins similar in size andlocation to the HP 4000

5. Take the Dremel tool with the grinding bit and carefully grind off the caps covering the pins. The caps shown (right photo) werecarefully cut off w

8. Open the drum cover fully and remove the metal arm asshown. Although it is fairly easy to remove the entire cover it isnot necessary. Either hold t