HP TouchSmart 9300 Elite Uživatelská příručka

Procházejte online nebo si stáhněte Uživatelská příručka pro Barebones pro PC / pracovní stanice HP TouchSmart 9300 Elite. HP TouchSmart 9300 Elite Base Model All-in-One PC User manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk

Shrnutí obsahu

Strany 1 - Hardware Reference Guide

Hardware Reference GuideHP TouchSmart 9300 Elite Business PC

Strany 2

Rear ComponentsFigure 1-4 Rear ComponentsTable 1-3 Rear ComponentsNo. Component No. Component1 Drive access panel 10 Power indicator light2 Webcam a

Strany 3 - About This Book

Keyboard FeaturesFigure 1-5 Keyboard FeaturesTable 1-4 Keyboard FeaturesNo. Component No. Component1 Sleep 9 Eject (F8)2 Windows Help (F1) 10 Displa

Strany 4

Figure 1-6 Remote Control FeaturesTable 1-5 Remote Control FeaturesNo. Button Function1 On/Off Puts the computer into and out of a power-reduced Sle

Strany 5 - Table of contents

Table 1-5 Remote Control Features (continued)No. Button Function11 Start Opens Windows Media Center main menu.12 Volume Increases (+) or decreases (–

Strany 6

Adjusting the SwivelThe computer has a swivel wheel on the underside of the base that allows you to swivel the computerleft or right for the best view

Strany 7 - 1 Product Features

2 Hardware UpgradesWarnings and CautionsBefore performing upgrades be sure to carefully read all of the applicable instructions, cautions, andwarnings

Strany 8 - Front Components

Connecting Power1. Squeeze the two tabs on the rear port access door at the back of the computer (1) and pull thedoor open (2).Figure 2-1 Opening the

Strany 9 - Side Components

5. Close the rear port access door.Figure 2-3 Closing the Rear Port Access DoorDisconnecting Power1. Remove all removable media, such as compact disc

Strany 10 - Rear Components

Installing the Rear Port Security Cover1. Ensure that all cables are connected and the rear port access door is closed.2. Tilt the display head to its

Strany 11 - Remote Control Features

3. Loosen the captive screw (1) and slide the security cover out of the center cavity (2).Figure 2-6 Removing the Rear Port Security CoverInstalling

Strany 12

© Copyright 2011 Hewlett-PackardDevelopment Company, L.P. Theinformation contained herein is subject tochange without notice.Microsoft, Windows, and W

Strany 13

Populating SODIMM SocketsThe memory sockets on the system board can be populated with up to four industry-standardSODIMMs. These memory sockets are po

Strany 14 - Adjusting the Swivel

The system will automatically operate in single channel mode, dual channel mode, or flex mode,depending on how the SODIMMs are installed.●The system w

Strany 15 - 2 Hardware Upgrades

9. Remove the small center panel below the rear ports by pulling out the top of the panel (1) thenlifting the panel off the computer (2).Figure 2-8 R

Strany 16 - Connecting Power

11. Remove the screw beneath the cover plate (1) and slide the memory access panel toward thecenter of the computer until it stops (approximately 5 mm

Strany 17 - Disconnecting Power

13. To remove a SODIMM, press outward on the two latches on each side of the SODIMM (1) thenpull the SODIMM out of the socket (2).Figure 2-12 Removin

Strany 18

15. To replace the memory access panel, hold the panel at a slight angle with the inside edge of thepanel lower than the outside edge, then slide the

Strany 19 - Installing Memory

17. Replace the screw cover plate, pressing the top of the cover plate in position first then pressingthe bottom of the cover plate in position.Figure

Strany 20 - Populating SODIMM Sockets

Replacing the Hard DriveThe hard drive is located under the drive access panel on the left side of the computer (when viewedfrom behind). The drive is

Strany 21 - Installing SODIMMS

10. Before removing the drive access panel, you must remove the small cover plate that hides thescrew used to secure the panel to the chassis. Lift up

Strany 22

12. Lift up the outside edge of the panel approximately 2.5 cm (1 inch) (1) and slide the panel towardthe outside edge of the computer (2) to remove i

Strany 23

About This BookThis guide provides basic information for upgrading this computer model.WARNING! Text set off in this manner indicates that failure to

Strany 24

14. Grasp the handle on top of the hard drive cage and slide the cage toward the outer edge of thecomputer, then lift the cage out of the computer.Fig

Strany 25

16. Slide the new hard drive into the hard drive cage (1) making sure that the connectors on thehard drive are on the same end of the cage as the hand

Strany 26

18. Tighten the captive screw to secure the hard drive cage in place.Figure 2-27 Tightening the Hard Drive Cage Screw19. To replace the drive access

Strany 27 - Replacing the Hard Drive

20. Lower the outside edge of the panel onto the computer then slide the panel towards the outsideof the computer (1) and install the screw (2) to sec

Strany 28

22. Replace the small center panel below the rear ports by inserting the bottom of the panel intoposition first (1) then rotating the top of the panel

Strany 29

wire cable attached. You attach one end of the cable to your desk (or other stationary object) and theother end of the cable to the security slot on t

Strany 30

On position (the keyboard does not have a Power switch). Then, turn on the computer. If you havetrouble using the keyboard and mouse, manually synchro

Strany 31

7. Press the Connect button on the bottom of the keyboard (3) for five seconds. The blue activityLED from the wireless receiver illuminates when the s

Strany 32

To use the remote control with a set-top box:1. To use the remote control so that the signal is received by the computer, connect an IR emitter(blaste

Strany 33

4. When you use the remote control, point it at the front of the computer, not at the set-top box.Figure 2-36 Using the Remote ControlConnecting a Se

Strany 35

3. If your second display has a DisplayPort, connect a DisplayPort cable directly between theDisplayPort on the rear of the computer (1) and the Displ

Strany 36

Additional InformationFor more information on removing and replacing hardware components, desktop management, theComputer Setup utility, and troublesh

Strany 37

A Electrostatic DischargeA discharge of static electricity from a finger or other conductor may damage system boards or otherstatic-sensitive devices.

Strany 38

B Computer Operating Guidelines,Routine Care and Shipping PreparationComputer Operating Guidelines and Routine CareFollow these guidelines to properly

Strany 39 - Connecting a Second Display

Optical Drive PrecautionsBe sure to observe the following guidelines while operating or cleaning the optical drive.●Do not move the drive during opera

Strany 40

IndexAadditional information 35Ccomputer operating guidelines 37DDisplayPort video adapterconnecting 33Eelectrostatic discharge, preventingdamage 36Ff

Strany 41 - Additional Information

Table of contents1 Product Features ...

Strany 43

1 Product FeaturesOverviewFigure 1-1 HP TouchSmart 9300 Elite Business PCNOTE: The wireless keyboard and mouse shown above are optional accessories.T

Strany 44 - Shipping Preparation

●Four SODIMM slots with up to 16 GB of DDR3 SDRAM memory and dual channel support● Up to 1 TB hard drive, or up to 300 GB Solid State Drive● HP Su

Strany 45

Table 1-1 Front Components (continued)No. Component No. Component2 Dual microphone array (optional) 5 High-performance stereo speakers3 Webcam (optio

Komentáře k této Příručce

Žádné komentáře