HP Workstation x4000 Specifikace stáhnout pdf (Strana 162)

Installing or Replacing Parts and Accessories

System Memory

Chapter 10160

5. Rotate the hard disk drive cage to the open position (see page 149).

6. Remove the chassis beam assembly (see page 152).

7. Remove the Memory Expander Card (MEC) (see page 155).

CAUTION You must remove the MEC to install RIMMs (and CRIMMs). The

MEC card guides are not strong enough to bear the force of the

RIMMs being inserted.

8. Install the RIMMs (and CRIMMs if required) on the MEC according

to Figure 10-10.

a. If you are installing additional RIMMs, you may need to remove

the CRIMMs. Open the retaining clips by pushing down on them,

and remove the CRIMM from the socket. See Figure 10-11 on

page 161.

b. If you are replacing existing RIMMs, open the retaining clips by

pushing down on them, and remove the existing RIMMs from

their sockets.

NOTE Always store any removed RIMMs and CRIMMs in a safe place for

future use. CRIMMs may be stored in an empty memory bank if one

is available.

c. Install your new RIMMs or CRIMMs, ensuring that the two

notches on the bottom edge are aligned with those of the socket.

With the two retaining clips open, press the RIMM fully into the

socket until the retaining clips click into position. You can also

close the retaining clips by hand to ensure that the RIMM is

correctly inserted.

1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 237 238

Žádné komentáře

HP Workstation x4000 Specifikace Strana 162