Hp 48g Graphing Calculator Uživatelský manuál stáhnout pdf (Strana 415)

100

101

4. Take any action:

■ To see the next program step displayed in the status area and

then executed, press ;5:5T .

■ To display but not execute the next one or two program steps,

press H £ X T .

■ To continue with normal execution, press S)(CONT],

B To abandon further execution, press KILL .

5. Repeat step 4 as desired.

To single-step from the middle of a program:

1. Insert a HALT command in the program where you want to begin

single-stepping.

2. Execute the program normally. The program stops when the HALT

command is executed, and the HRLT annunciator is displayed.

3. Take any action:

■ To see the next program step displayed in the status area and

then executed, press SST .

a To display but not execute the next one or two program steps,

press HEIKT .

■ To continue with normal execution, press pt^fCONT I.

fl To abandon further execution, press KILL .

4. Repeat step 3 as desired.

When you want the program to run normally again, remove the HALT

command from the program.

To single-step when the next step is a subroutine;

■ To execute the subroutine in one step, press :BST .

■ To execute the subroutine step-by-step, press :BST+ .

S S T executes the next step in a program—if the next step is a

subroutine, :3ST executes the subroutine in one step. :3ST4-

works just like SST —except if the next program step is a

subroutine, it single-stejis to the first step in the subroutine.

To turn off the HAL'." 'annuriCiator a?, anj tKiie;

Press f PRGl C

Programming the HP 48 29-9

1 2 ... 410 411 412 413 414 415 416 417 418 419 420 ... 611 612

Komentáře k této Příručce

Žádné komentáře

Hp 48g Graphing Calculator Uživatelský manuál Strana 415

Komentáře k této Příručce

Související produkty a manuály pro PDA Hp 48g Graphing Calculator