HP ap5000 All-in-One Point of Sale System Uživatelský manuál stáhnout pdf (Strana 15)

3 Computer Setup (F10) Utility

Computer Setup (F10) Utilities

Use Computer Setup (F10) Utility to do the following:

●

Change factory default settings.

●

Set the system date and time.

●

Set, view, change, or verify the system configuration, including settings for serial and parallel

ports.

●

View settings for processor and memory.

●

Modify the boot order of bootable devices.

●

Adjust the brightness of the LCD panel.

●

Establish a supervisor password that controls access to Computer Setup (F10) Utility and the

settings described in this section.

CAUTION: The VGA port on the ap5000 is a Powered VGA Port. If your monitor does not support

the “Powered VGA” feature, make sure to plug it in prior to powering on the POS system in order to

prevent possible damage to your monitor.

Using Computer Setup (F10) Utilities

Computer Setup can be accessed only by turning the computer on or restarting the system.

To access the Computer Setup Utilities menu, complete the following steps:

1. Turn on or restart the computer.

2. As soon as the computer is turned on, press F10 before the computer boots to the operating

system to enter Computer Setup.

NOTE: If you do not press F10 at the appropriate time, you must restart the computer and

again press F10 before the computer boots to the operating system to access the utility.

3. The Computer Setup Utility screen is divided into menu headings and actions.

Five menu headings appear on the Computer Setup Utility screen:

●

Main

● Advanced

● Boot

Computer Setup (F10) Utilities 7

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 88 89

Žádné komentáře

HP ap5000 All-in-One Point of Sale System Uživatelský manuál Strana 15