HP Hybrid POS Printer with MICR II Uživatelský manuál stáhnout pdf (Strana 17)

Test procedure

1. To run the test, open the receipt cover (1); then, while holding down the paper feed button (2), close the

receipt cover (3).

2. When the printer begins printing let go of the paper feed button. The diagnostic printout will print.

3. Review this printout for printer settings. If you want to change any of these settings, go to the

conguration menu as instructed at the bottom of the printout.

4. Make selections as instructed on the printout.

IMPORTANT: When changing any of the printer settings, be extremely careful to avoid inadvertently

changing other settings that might aect the performance of the printer.

Test printout

Paper type can be changed in the conguration menu. Available paper types and grades are shown in

following table.

Paper types and grades

Type 0 Monochrome grades

Type 4 Two-color grades

Type 5 Two-color grades

Refer to Paper requirements on page 27 for more information.

Printer congurations

Printers are shipped with preset functions and parameters, but you can change these settings manually. The

instructions for accessing the menu appear on the bottom of the test printout receipt.

IMPORTANT: When changing any of the printer settings, be extremely careful to avoid inadvertently

changing other settings that might aect the performance of the printer.

The following functions and parameters can be changed in the scrolling conguration menu:

●

Communication interface

Universal Serial Bus (USB)

●

Diagnostic modes

Printer congurations 11

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 44 45

Žádné komentáře

HP Hybrid POS Printer with MICR II Uživatelský manuál Strana 17