HP 600N Instalační manuál stáhnout pdf (Strana 31)

Control Panel Configuration 3-5

Control Panel

Configuration

To configure an IPX frame type

If you have not already done so, enable the IPX/SPX protocol

(IPX/SPX=ON*) by following the instructions described in “To enable

or disable network protocols” in this chapter.

1. Take the printer offline by pressing [Go]. The “Ready” LED

should be off.

2. Press

[Menu] repeatedly until EIO # JETDIRECT MENU is displayed

(# identifies the EIO slot number of the card).

3. Press [Item] until CFG NETWORK=NO* appears.

NO* indicates that access to the EIO JetDirect network menus

will be bypassed. You must change this to CFG NETWORK=YES* to

access the EIO JetDirect menus:

a. Press [Value]. CFG NETWORK=YES appears.

b. Press [Select]. CFG NETWORK=YES* appears.

4. Press [Item] to scroll through each network protocol until

CFG IPX/SPX=NO* is displayed.

To access the IPX/SPX configuration menu, press [Value] and

then press [Select] to display CFG IPX/SPX=YES*.

5. Press [Item] until FRAME=<Frame Type>* appears.

6. To activate the printer and save your changes, press [Go].

AUTO

EN_8023

EN_II

EN_8022

EN_SNAP

TR_8022

TR_SNAP

●

To change the frame type, press

[Value]

until

the desired option appears, and then press

[Select]

●

Press

[Item]

to continue to the next

parameter.

Note:

An asterisk (*) indicates the active frame type selected.

The available frame type options depend on whether you have an

Ethernet or Token Ring card installed.

S00eiohw.book Page 5 Thursday, February 24, 2000 2:26 PM

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 53 54

Komentáře k této Příručce

Žádné komentáře

HP 600N Instalační manuál Strana 31

Komentáře k této Příručce

Související produkty a manuály pro Tiskové servery HP 600N