HP Access Control Rychlý návod stáhnout pdf (Strana 61)

1. In the Devices tile, select the Lexmark printer from the device list.

2. Click the Install button.

Please wait a few minutes for the AC Lexmark Applications solution to install. To check the status of the

printer, go to the printer’s EWS. The current status of the device displays in the page header. If the status is

“Busy” or “Not Ready”, the applications are installing.

5.10.2 Configure AC Lexmark Applications

NOTE: The administration pages may vary, depending on the model of the Lexmark printer.

Configuration of the AC Lexmark Applications solution consists of pointing the AC Authentication and the

Card Enroll applications to the AC server. Follow the steps below:

1. In the Devices tile, right-click the Lexmark printer and select Go to printer ews.

2. On the printer admin page, select Settings.

3. Select Apps or Embedded Solutions, depending on the firmware version installed, to view the list of

installed applications.

4. Select the Authentication solution.

5. Select Configure.

6. Update the AC Server URL with the appropriate server address. Click Apply.

7. Repeat this process for the Card Enroll application.

5.10.3 Lexmark device security settings

Configuration of the Lexmark security settings allows the AC server to control what on-device applications a

user has access to.

NOTE: Since setting up security on a device is a lengthy process it is recommended that system

administrators look into device cloning and other administration tools available from Lexmark.

NOTE: If users encounter authorization problems, users will have to logout and re-authenticate. This issue

occurs only when a user authenticates and is properly authorized in one application then attempts to access

another application.

Section 5.10 Install and configure components on Lexmark devices 53

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 70 71

Žádné komentáře

HP Access Control Rychlý návod Strana 61