Hp 220 Uživatelský manuál stáhnout pdf (Strana 190)

9Ć12 Product History and Service Notes

C3187Ć90000

    

Engaging lever

EngagingĆlever spring

Screw

(Remove from inside)

Left sideplate

YĆtensioner bracket

CamĆgear support

Auto cam

IMPORTANT: You need a scissors as well as the tools listed in chapter 6.

1. Remove the window assembly and the left endĆcover.

2. Remove the the bail assembly, the encoder strip and the service station.

3. Remove the primer assembly.

4. Remove the YĆtensioner bracket and related assemblies.

5. Using scissors or a cutter, cut the teflon washers.

6. Using needleĆnose pliers, remove the teflon washers.

IMPORTANT: Ensure that you have removed all the teflon washers and that you are not

leaving any fragment between the sideĆplate and the autoĆcam.

If you are not able to remove them, perform the following additional steps:

a. Disassemble the plotter to access the automatic bailĆlift mechanism following the

procedure described in chapter 6.

b. ReĆinstall the bailĆlift mechanism WITHOUT the teflon washers.

7. Place the camĆgear support into the slot on the NEW YĆtensioner bracket included in the

bailĆmechanism assembly.

8. Install the YĆtensioner bracket on the left sideplate. Tighten the two left screws and leave

the right one loose.

1 2 ... 185 186 187 188 189 190 191 192 193 194 195 ... 245 246

Žádné komentáře

Hp 220 Uživatelský manuál Strana 190