Hp 3380 Uživatelský manuál stáhnout pdf (Strana 115)

Paper-handling problems exist

Print is skewed (crooked)

Are the media guides adjusted properly?

Remove all media from the input tray, straighten the stack, and load the media in the input tray

again. Adjust the media guides to the width and length of the media that you are using and try

reprinting. See

Device media specifications or the start guide for more information.

More than one sheet feeds at one time

Is the media input tray too full?

See the start guide for more information.

Is the media wrinkled, folded, or damaged?

Make sure the media is not wrinkled, folded, or damaged. Try media from a new or different

package.

Is the device separation pad worn?

See Replacing the device separation pad for more information.

Device does not pull media from the media input tray

Is the device in manual feed mode?

Try one of the following:

● If Manual feed appears on the device control panel display, press

ENTER

to print the

job.

● Make sure that the device is not in manual feed mode and print your job again.

Is the pickup roller dirty or damaged?

Clean or replace the pickup roller and print your job again. See Cleaning the pickup roller or

Replacing the pickup roller for instructions.

Media curls when fed through device

● Open the straight-through output door to print straight through.

● See

Curl or wave for more information.

ENWW Paper-handling problems exist 103

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 195 196

Žádné komentáře

Hp 3380 Uživatelský manuál Strana 115