HP 705 Specifikace stáhnout pdf (Strana 91)

6. Press inward on the release lever at the rear of the drive (1) and slide the drive out of the rear of

the drive bay (2).

Installing a 3.5-inch device

1. Prepare the computer for disassembly (Preparation for disassembly on page 66).

2. Remove the access panel (

Access panel on page 67).

3. Remove the front bezel (

Front bezel on page 67). If you are installing a drive in a bay covered by

a bezel blank, remove the bezel blank. See

Bezel blanks on page 69 for more information.

4. Install 6-32 guide screws in the holes on each side of the drive.

NOTE: HP has supplied four extra 6-32 guide screws on top of the drive cage. Refer to

Installing and Removing Drives on page 78 for an illustration of the location of the extra guide

screws.

When replacing a drive, transfer the four 6-32 guide screws from the old drive to the new one.

5. Rotate the drive cage to its upright position.

Drives 81

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 205 206

Žádné komentáře

HP 705 Specifikace Strana 91