HP Blade Workstation Client Uživatelský manuál stáhnout pdf (Strana 130)

HP Remote Graphics 4.2.0 User's Guide

122

Enabling mute on some devices will prevent audio from arriving at the

receiver. The Realtek audio device used in the HP xw4300 is known to have

this issue. One possible solution when running the 32 bit version of Windows

XP is to disable the audio device prior to installing the sender. This will cause

the HP Remote Audio device driver to be installed. The real audio device and

the HP Remote Audio device should not be enabled at the same time. The

sender will connect to the first audio device it detects, which may not be the

device that is selected by the user.

2. RGS Receiver Audio Controls Are Disabled on a Receiver for Linux:

The audio controls will be disabled when the receiver cannot open or

communicate with the JACK audio server (jackd). The status can be

determined with the hprgsaudio script:

• /opt/hpremote/rgreceiver/hprgsaudio status

This reports the existence of a user-owned jackd audio server.

• /opt/hpremote/rgreceiver/hprgsaudio start

This will attempt to manually start of the jackd audio server if it is not

running.

• /opt/hpremote/rgreceiver/hprgsaudio stop

This will attempt to manually stop the jackd audio server if unused by

rgreceiver.

• /opt/hpremote/rgreceiver/hprgsaudio restart

This will attempt to shutdown and restart jackd if possible.

The hprgsaudio script should always be the preferred method of managing

jackd.

Note: Audio is not supported on HP-UX.

3. No Audio on Windows Receiver:

Verify that your local audio device is working. The volume control slider on

the Receiver should play the default beep when released. Make certain that

the mute is not enabled. Refer to the Windows Sender Audio Installation

section for information on selecting the mixer as the input line. Refer to the

Windows Sender Audio Calibration for information on how to ensure the

volume levels are not too low. Make sure the mute is not enabled on the

Wave line of the sender or receivers Volume Control.

4. No Audio on Linux Receiver:

Installations that fail to yield any sound should observe the following

checklist:

1. Verify the sender system is configured properly to use the correct

recording device and is recording from the correct source.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 154 155

Žádné komentáře

HP Blade Workstation Client Uživatelský manuál Strana 130