HP Imaging and Printing Security Center Uživatelská příručka stáhnout pdf (Strana 13)

Verify global remediation setting

Before running the first assessment, HP recommends that you verify the global remediation setting,

which controls whether an out-of-compliance device is remediated (corrected) during the assessment

process. This setting applies to all policies and takes precedence over an individual policy's

advanced remediation settings (Advanced Policy Settings). When the HP IPSC is first installed, the

default for the global remediation setting is Enable device remediation (Remediate and Report).

NOTE: You can also control how individual out-of-compliance policy items are processed during

remediation using the policy's Advanced Policy Settings. Options are provided for whether to

remediate out of compliance items and how to process unsupported devices. For more information,

see

Set severity, remediation, and unsupported behavior on page 18.

Use the following steps to set the global remediation option:

1. Start the HP IPSC, click File, and then click Settings.

2. Click the General tab.

3. Select the Enable device remediation (Remediate and Report) check box if you want the HP

IPSC to remediate out-of-compliance devices.

4. Select the Disable device remediation (Report Only) check box if you do not want out-of-

compliance devices remediated.

You might want to disable device remediation to prevent accidental changes to devices on your

network.

5. Click OK to save your entries.

ENWW Verify global remediation setting 9

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Žádné komentáře

HP Imaging and Printing Security Center Uživatelská příručka Strana 13