HP Netserver 5971-0821 Uživatelský manuál stáhnout pdf (Strana 74)

NOTE Remember that UNIX commands are case sensitive. Enter the

commands exactly as shown in the instructions.

1. Insert the SCO OpenServer 5.0.x boot disk into the primary floppy disk

drive and turn ON the computer. Alternatively, insert the SCO OpenServer

5.0.x boot CD into the primary CD-ROM drive and turn ON the computer.

When you see these prompts:

SCO OpenServer (TM) Release 5

Boot

Type ahslink and press Enter. (The boot drive should be ID0 or ID1.)

2. Type ad160 as the package you want to link to the system and press Enter.

3. Insert the requested volume (the Ultra3 Family Manager Set disk for SCO

OpenServer) in the floppy disk drive and press Enter.

4. If the driver is properly loaded, the following message appears:

ad160.adl60:Loading module

fd(52)/ad160/driver/ad160/Driver.o text....

adl6O: Driver “adl6O” successfully loaded.

5. Follow the procedures in your SCO OpenServer documentation for

completing the installation.

Installing the Driver When SCO OpenServer is

Already Installed

To update or install the adl6O driver if SCO OpenServer is already installed,

follow the instructions in this section. The procedures are similar for all

versions of SCO OpenServer. Procedures that are specific to a SCO version are

noted when necessary.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 119 120

Žádné komentáře

HP Netserver 5971-0821 Uživatelský manuál Strana 74