Hp Remote Device Access Software Uživatelský manuál stáhnout pdf (Strana 30)

Active Tunnels

When an HP Support Agent is running a connection through your vCAS to elsewhere in your network, the

connection appears as an active tunnel on your vCAS. Each active tunnel displays on the Active Tunnels

and Logins tab, as a row in the Active Tunnels table.

Figure 4.1 Active Tunnels Table

The Active Tunnels screen contains the following columns:

Column Description

User The name of the user who initiated the tunnel.

From The short host name or IP address of the system (within HP) where the tunnel

originates.

Target The short host name or IP address of the system (within your network) where the

tunnel emerges.

Port The port on the target system to which the tunnel is directed.

Proto The traffic protocol (tcp or udp) used by the tunnel.

Start The time in ISO 8601 format when the tunnel started.

Duration The length of time that the tunnel has been active.

Action Click to force the tunnel to close and to terminate all traffic through that tunnel.

Table 4.1 Active Tunnels

Note: If there are no active tunnels, then No active tunnels appears in the table.

Logins

If an HP Support Agent or local user is logged on to a command shell on your vCAS, their session appears

on the Active Tunnels and Logins tab, in the Logged-In Users table.

HP Remote Device Access 8.1:vCAS User Guide Page 30 of 65

Chapter 4: Managing your vCAS

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 64 65

Žádné komentáře

Hp Remote Device Access Software Uživatelský manuál Strana 30