Hp EML E-series Tape Libraries Uživatelský manuál stáhnout pdf (Strana 75)

Load port magazine

375813-001Part number

Inside the load port door on the right side of the base module, tape

drive expansion module, and capacity expansion module

Location

One column, five slotsCharacteristics

Holding tape cartridges for placement into libraryFunction

Illustration

Removing a load port magazine

1. On the OCP, select the Operations→Unlock Load Ports command. All load port doors open.

2. Fully open the load port door.

3. Grab the handle and pull the magazine out of the load port along its track to remove it from

the library.

CAUTION: Guard plates prevent access to the inside of the library when a load port

magazine is removed. These doors will move back out of the way when a magazine is

reinserted. You should not attempt to otherwise move these guards, nor gain access to the

library through the load ports.

Replacing a load port magazine

1. Align the magazine with the top and bottom track on the load port door, and slide the

magazine through the spring door and fully into the load port.

2. Close the load port door.

Load port magazine 75

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 111 112

Žádné komentáře

Hp EML E-series Tape Libraries Uživatelský manuál Strana 75