HP ES80 Instalační manuál stáhnout pdf (Strana 23)

Installation and Use with the OpenVMS Operating System 2-5

Job iCAP$ALPHA (queue ICAP$ALPHA$BATCH, entry 7) holding

until 5-DEC-2005 10:05

3.0 Verifying iCAP Installation

To verify if iCAP is installed, execute the following DCL command:

$ PRODUCT SHOW PRODUCT iCAP

The following information will be displayed:

------------------------------- ------------ -----

PRODUCT KIT TYPE STATE

------------------------------- ------------ -----

HP AXPVMS iCAP V1.6-1 Full LP Installed

------------------------------- ----------- --------

1 item found

4.0 Activating iCAP CPUs

Once iCAP has been installed, you can see which CPUs are active and which

are not currently active by using the DCL command SHOW CPU. For example:

$ SHOW CPU

The following information is displayed:

ALPHA, a AlphaServer GS160 6/731

Multiprocessing is ENABLED. Streamlined synchronization image loaded.

Minimum multiprocessing revision levels: CPU = 1

PRIMARY CPU = 00

CPU sets:

Active 00 01

Configure 00 01 04 05

Potential 00 01 04 05

Autostart 00 01 04 05

Failover None

For ES47, ES80 and GS1280, an inactive iCAP CPU cannot be connected to

either internal I/O (ES47 & ES80) or an external I/O Building Block Drawer.

1. ES47 & ES80: One CPU on the iCAP Dual CPU Building Block Module

must remain active, and the active CPU must be the one connected to the

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Žádné komentáře

HP ES80 Instalační manuál Strana 23