HP G1 Rychlý návod stáhnout pdf (Strana 45)

General tasks

Activating Drive Encryption for standard hard drives

Standard hard drives are encrypted using software encryption. Follow these steps to activate Drive

Encryption:

1. Launch HP ProtectTools Administrative Console. For more information, see

Opening HP

ProtectTools Administrative Console on page 15.

2. In the left panel, click Setup Wizard.

3. Select the Drive Encryption check box, and then click Next.

4. To back up the encryption key, connect an external device for recording this key. This key must

be used to access the data if other methods fail.

5. Under Back up Drive Encryption keys, select the check box for the storage device where the

encryption key will be saved.

6. Click Next.

NOTE: You are prompted to restart the computer. After restart, the Drive Encryption pre-boot

screen is displayed, requiring authentication before Windows will start.

Drive Encryption has been activated. Encryption of the selected drive partition(s) might take a number

of hours, depending on the number and size of the partition(s).

See the HP ProtectTools Security Manager software Help for more information.

Activating Drive Encryption for self-encrypting drives

Self-encrypting drives meeting Trusted Computing Group's OPAL specification for self-encrypting

drive management can be encrypted using either software encryption or hardware encryption. Follow

these steps to activate Drive Encryption for self-encrypting drives:

NOTE: Hardware encryption is available only if ALL drives in your computer are self-encrypting

drives meeting Trusted Computing Group's OPAL specification for self-encrypting drive management.

In this case, the Use hardware drive encryption option is available, and either hardware or software

encryption can be used.

If there is a mix of self-encrypting drives and standard hard drives, then the Use hardware drive

encryption option is not available, and only software encryption can be used. For more information,

see

Activating Drive Encryption for standard hard drives on page 39.

▲

Use the HP ProtectTools Security Manager Setup Wizard to activate Drive Encryption.

– or –

Software encryption

1. Launch HP ProtectTools Administrative Console. For more information, see

Opening HP

ProtectTools Administrative Console on page 15.

2. In the left panel, click Setup Wizard.

3. Select the Drive Encryption check box, and then click Next.

NOTE: If the Use hardware drive encryption option is available at the bottom of the screen,

clear the check box.

General tasks 39

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 70 71

Komentáře k této Příručce

Žádné komentáře

HP G1 Rychlý návod Strana 45

Komentáře k této Příručce

Související produkty a manuály pro ne HP G1