HP Elite Slice for Meeting Rooms G2 for Intel Unite Uživatelský manuál stáhnout pdf (Strana 41)

Removing and replacing a SATA SSD

NOTE: Back up the SSD before you remove it so that you can transfer the data to the new SSD.

To add an SSD instead of replacing one, purchase a 4-screw after-market option kit to obtain the screws

required to mount the drive.

1. Remove the access panel.

For instructions, see Removing the access panel on page 27.

2. Remove the 4 screws (1) attaching the SSD cage to the system board and lift the cage (2) out of the

chassis.

3. Pull the tab (3) to disconnect the SSD power-and-data cable from the SSD.

4. Remove the screws (1) securing the SSD in the cage and lift the SSD (2) out of the cage.

5. Position the new SSD over the drive cage with the SSD connectors at the end with the thermal patch and

the circuit board side facing the closed side of the drive cage.

Removing and replacing a SATA SSD 33

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 53 54

Žádné komentáře

HP Elite Slice for Meeting Rooms G2 for Intel Unite Uživatelský manuál Strana 41