HP ElitePad 1000 G2 Rugged Tablet Uživatelský manuál stáhnout pdf (Strana 35)

To return audio to the tablet speakers, follow these steps:

1. From the Windows desktop, tap and hold the Speakers icon in the notication area, at the far right of

the taskbar, and then select Playback devices.

2. On the Playback tab, select Speakers.

3. Select Set Default, and then select OK.

Bar-code scanner (select models only)

To use the bar-code scanner:

1. Open a bar-code reading utility (sold separately) that you have installed on the tablet.

2. Press and hold one of the bar-code scanner buttons, and aim the scanner beam at the bar code.

3. The cross is the center of the eld of view and the red dots are the border. Make sure that the scanner

beam covers the entire bar code.

TIP: For best results, steady the tablet using both hands, with the scanner lens 152.4 or 177.8

millimeters (6 or 7 inches) from the bar code.

WARNING! Do not look at the scanner beam with a magnifying device positioned closer than 100 mm

(3.9 in). Doing so can cause an eye injury.

4. A green dot appears after a successful scan.

NOTE: For more information about programming the bar-code scanner, go to http://www.datalogic.com/.

Conguring carriage returns

To congure the bar-code scanner to insert a carriage return after each scanned bar code:

1. Open programming mode by scanning the following QR code.

Bar-code scanner (select models only) 25

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 80 81

Žádné komentáře

HP ElitePad 1000 G2 Rugged Tablet Uživatelský manuál Strana 35