HP MP4 Uživatelský manuál stáhnout pdf (Strana 22)

Installing a flash memory module

Before beginning the installation process, review General hardware installation sequence on page 7

for procedures you should follow before and after installing or replacing hardware.

WARNING! You must remove the left side panel to access the system board. Before removing the

side access panel, ensure that the digital signage player is turned off and the power cord is

disconnected from the electrical outlet.

CAUTION: Static electricity can damage the electronic components of the computer or optional

cards. Before beginning these procedures, ensure that you are discharged of static electricity by

briefly touching a grounded metal object. When handling a memory module, be careful not to touch

any of the contacts. Doing so may damage the module.

To install the flash memory module:

1. Locate the correct flash memory module socket on the system board.

a. The PATA socket (1) is populated by default.

b. The SATA socket (2) can be populated with an optional SATA flash memory module.

Figure 2-12 Identifying the flash memory module sockets

16 Chapter 2 Hardware changes

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 36 37

Žádné komentáře

HP MP4 Uživatelský manuál Strana 22