HP Remote Graphics Software (RGS) Uživatelský manuál stáhnout pdf (Strana 30)

100

101

Performance

The performance settings allow you to improve the interactive experience. Typically, these adjustments will

be made when working with highly interactive applications (such as a CAD application) in a low-bandwidth or

high-latency network environment.

The following table describes the settings available in the Performance panel.

Setting Description

Enable HP Velocity

NOTE: Windows/Linux only

Enables HP Velocity.

Advanced Video Compression on Sender

NOTE: Windows/Linux only

Enables Advanced Video Compression.

Image Quality Sets the maximum image quality.

When not using Adaptive image quality, RGS will maintain the image quality specied by

this option. When selecting Adaptive image quality, RGS will use this option’s setting as

the target image quality when the updates-per-second value allows.

NOTE: This option is duplicated on the RGS Receiver toolbar.

Enable adaptive image quality

Increase text rendering quality

Minimum image quality

Target update rate

When Enable adaptive image quality is selected, RGS will begin to degrade the image

quality down to the Minimum image quality setting (from 0–100) anytime the updates-

per-second value falls below the Target update rate (from 0–30 updates per second).

When Increase text rendering quality is selected, RGS uses dierent encoding for areas

of the sender's display with few colors (such as most text) to increase the quality when

those areas are displayed on the receiver. In video-centric or bandwidth-constrained

environments, disabling this option might improve RGS performance.

NOTE: These options are disabled when Advanced Video Compression is enabled.

TIP: See Performance optimization on page 68 for more information about ways to optimize RGS performance.

Gesture (Windows touch only)

NOTE: These features are not supported on Windows 7.

You can use the gesture settings to map hotkey sequences to the gestures that are not used by RGS by

default. For a list of the gestures that can be customized, see Using touch features (Windows only, touch GUI

only) on page 38.

To map a hotkey sequence to a gesture:

1. Select the pencil icon in the row of the desired gesture.

2. Enter the key sequence.

3. Optionally select Enable sticky gesture if you want the gesture to mimic the continual press of the

hotkey sequence until the same gesture is used to disable the sequence.

4. Select Save.

To un-map a hotkey sequence from a gesture:

▲

Select the X icon in the row of the desired gesture.

20 Chapter 4 RGS Receiver overview

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 100 101

Komentáře k této Příručce

Žádné komentáře

HP Remote Graphics Software (RGS) Uživatelský manuál Strana 30

Komentáře k této Příručce

Související produkty a manuály pro ne HP Remote Graphics Software (RGS)