HP Web Jetadmin Software Uživatelský manuál stáhnout pdf (Strana 33)

●

SNMP Version Access Control conguration option: The MD5 authentication and DES privacy protocols

must not be specied.

●

IPsec/Firewall Policy conguration option: The DES-CBC-MD5 algorithm must not be specied for the

Kerberos setting.

●

Upload Jetdirect Certicate conguration option: Certicates must not be signed by using MD5 or

earlier (MD2 or MD4).

●

Upload CA Certicate conguration option: Certicates must not be signed by using MD5 or earlier

(MD2 or MD4).

●

Mgmt Protocol conguration option: The SSL 3.0 or earlier protocol must not be enabled.

HP Web Jetadmin does not report the exact reason for the failure. However, if you enable FIPS-140 mode

by using the device HP Embedded Web Server (EWS), the EWS does report the exact reason for the failure.

The FIPS-140 mode setting is available in the EWS from the Networking tab > Security link > Settings page.

Enable FIPS on the HP Web Jetadmin server

1. Stop the following services. These services must be stopped in the specied order.

a. HPWSProAdapter

b. HPWJAService

c. mssql$HPWJA

2. Use the following steps to enable FIPS on the HP Web Jetadmin server as a local security policy:

TIP: For more information about the System cryptography setting, see the “System cryptography: Use

FIPS compliant algorithms for encryption, hashing, and signing" security setting eects in Windows XP and in

later versions of Windows document. This document is available from the Microsoft support page.

a. Go to Control Panel > Administrative Tools > Local Security Policy > Local Policies > Security Options.

b. Right-click System cryptography: Use FIPS compliant algorithms for encryption, hashing and signing,

and then select Properties.

c. On the Local Security Setting tab, select the Enabled option, and then click the OK button.

3. Start the following services. These services must be started in the specied order.

a. mssql$HPWJA

b. HPWJAService

c. HPWSProAdapter

4. Use the following steps to verify that HP Web Jetadmin can communicate with all of the devices:

a. In the All Devices list, look for any devices that have Device Communication Error in the Status

column.

b. Verify that you can congure a device by using HP Web Jetadmin.

c. In the All Devices list, right-click a device, and then select Refresh Selection (Full). Verify that the

refresh completed.

If there are any devices that have a status of Device Communication Error or you cannot complete step b or

c, access the device EWS, and then verify the following settings:

ENWW Enable FIPS on the HP Web Jetadmin Server 29

1 2 ... 28 29 30 31 32 33 34 35 36 37

Komentáře k této Příručce

Žádné komentáře

HP Web Jetadmin Software Uživatelský manuál Strana 33

Komentáře k této Příručce

Související produkty a manuály pro ne HP Web Jetadmin Software