HP HyperFabric Uživatelská příručka stáhnout pdf (Strana 128)

Managing HyperFabric

Verifying Communications within the Fabric

Chapter 5114

NOTE Also see the clic_diag command to:

Probe a speciﬁc remote node.

Dump and format trace data.

Set the tracing level for the HyperFabric software and ﬁrmware.

The clic_diag command is detailed in the section, “Running

Diagnostics” on page 133.

Examples of clic_probe

Some examples of using clic_probe are shown below.

• Example 1

If the local node is bently6 and you want to send ﬁve packets to

verify that the adapter clic0 (which is on bently6) is able to handle

trafﬁc, issue this command:

clic_probe -l -c clic0 -p 5

The generated output could look like this:

CLIC_PROBE: 256 byte packets

Local Loopback: Source and Target Adapter ID: bently6.corp

3.com:clic0

256 bytes: seq_num = 1. Packet Acknowledged.

256 bytes: seq_num = 2. Packet Acknowledged.

256 bytes: seq_num = 3. Packet Acknowledged.

256 bytes: seq_num = 4. Packet Acknowledged.

256 bytes: seq_num = 5. Packet Acknowledged.

--------- bently6.corp3.com CLIC_PROBE Statistics --------

5 packets transmitted, 5 packets received, 0% packet loss.

• Example 2

If the local node is bently6, and you want to verify communications

with the remote node bently4, issue this command:

clic_probe bently4

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 189 190

Žádné komentáře

HP HyperFabric Uživatelská příručka Strana 128